How can I reattach the bumper? Clips are broken from it bottoming out on driveways..
It has also had a slight hit on passenger front just hit a rock with bumper nothing major.. its my mums 2011 Lancer. Am I best off finding another bumper? You can pull the bumper away from the body and its loose right around infront of the light.. car is too low for my mum.. its stock height aswell.. told her not to buy a Lancer
Comments
Duct tape.
Or just delete the bumpers.
Ducktape always win😛
It’s happen to my friend’s cefiro, but he said “who’s care with that ? It’s a drift missile tho !”
This car is far from one…
Get new clips, epoxy resins or job weld them on, slap bumper back on
I do not know if it is available down in Australia. But I have used Gorilla Glue for exactly that. It expands a little bit to fill in any gap. Makes a heck of a strong bond too if the surfaces are clean.
I havent heard of it but ill have a look
Buy new clips. They’ll be pretty cheap from the mitsubishi dealership. Ask then for parts. They’ll redirect you if you call.
There might be some scews that may need some tightening. Hope this helps
Thank you
Zip tie it to the inside of the bumper, so no one can see. You need to be careful drilling the holes though.
Or you could make your own tabs and epoxy it to the bumper.
Get new tabs, glue it in, screw it in from the inside. There’s some ideas.
Thank.you 🙄
Go to Harbor Freight, buy a flux-core welder and some steel tubing, remove the bumper, and weld up a custom bash bar.
With a hammer.