96 honda accord project.
A few weeks ago I acquired this "beautiful" piece. A 96 honda accord EX sedan

A beat up, riced out hunk of……potential. there is almost more bare metal and scratches visible than paint. There is hail damage on the hood and the trunk but not the body. It has all the nice ricer mods so already I’m off to a good start. Hot air intake, throttle body spacer, full exhaust with cat delete (so you know it sounds like $h!#). It’s been curbed destroying the suspension on the front left side. this all sucks and obviously these are the negative aspects about the car. But with all the bad I still see a lot of potential. So good with this car…Almost no Rust! Ya I know a 90s honda that has been in the north all of its life only has 1 Rust spot! No bond or body filler either! Also it has the f22b1 stock and for all of you that know honda that in many aspects is a good thing. Vtec baby! Anyways I have no $500 in it already that’s for all the parts you see in the back. Complete suspension replace for the front including, upper and lower control arms, sway bar links, the knuckles, both inner and outer tie rods, also both half shafts, and wheel bearings. Already has lowering springs on all four sides as you all well know as you’re not a real ricer if you were not tucking very hard. After all that was replaced which will be tomorrow the exterior update will commence. Which you will see in the next update.